Dalsa Linea SWIR GigE Series User Manual page 49

Counter Duration
Counter Value
Counter Value At Reset
Counter Reset
Timer Selector
Timer 1
Timer Mode
Off
Active
Timer Status
Timer Idle
Timer Trigger Wait
Timer Delaying
Timer Active
Timer Completed
TimerStartSource
TimerReset Cmd
Acquisition Start
Exposure Start
Frame Start
Line 1
Line 2
Timer 1 End
Counter 1 End
Timer Line Activation
Rising Edge
Falling Edge
Any Edge
Timer Delay
Timer Duration
Timer Value
Linea SWIR GigE Series Camera
counterDuration
counterValue
counterValueAtReset
counterReset
timerSelector
Timer1
timerMode
Active
timerStatus
TimerIdle
TimerTriggerWait
TimerDelaying
TimerActive
TimerCompleted
timerStartSource
AcquisitionStart
ExposureStart
FrameStart
Line1
Line2
Timer1End
Counter1End
timerStartLineActivation
RisingEdge
FallingEdge
AnyEdge
timerDelay
timerDuration
timerValue
Sets the duration (or number of events) before the
CounterEnd event is generated.
Read the current value of the selected counter.
(RO)
Reads the value of the selected counter when it
was reset by a trigger or by an explicit Counter
Reset command. (RO)
Resets the selected counter to zero. The counter
starts immediately after the reset. To temporarily
disable the counter, set the Counter Event Source
feature to Off. (WO)
Selects which timer to configure.
Configure Timer 1.
Select the timer mode. The selected Timer is Active
or Disabled. When Disabled, the Timer can be
configured.
Off The selected Timer is Disabled.
The selected Timer is Enabled.
Returns the current state of the timer. (RO)
The timer is idle. The CounterStartSource feature is
set to off.
The timer is waiting for a start trigger.
The timer is counting the requested delay.
The timer is counting for the specified duration.
The timer reached the TimerDuration count.
Select the trigger source to start the timer. The
Event Control section provides details and timing
diagrams for the supported events.
Off Start on reception of the TimerReset Icommand.
Start Timer on Acquisition Start event.
Start Timer on Exposure Start event.
Start Timer on Frame Start event.
Start Timer on a transition of I/O Line 1 event.
Start Timer on a transition of I/O Line 2 event.
Start Timer on Timer 1 End event.
Start Timer on Counter 1 End event.
Select the trigger activation mode which starts the
timer.
Starts counter on rising edge of the selected signal.
Starts counter on falling edge of the selected
signal.
Starts counter on the falling or rising edge of the
selected signal.
Sets the duration (in microseconds) of the delay to
apply at the reception of a trigger before starting
the timer.
Sets the duration (in microseconds) of the timer
pulse.
Reads the current value (in microseconds) of the
selected timer.
Operational Reference
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
•
47