Dalsa Linea SWIR GigE Series User Manual page 32

Load Configuration
Save Configuration
Device Built-In Self Test
Device Built-In Self Test
Status
Passed
Firmware Update Failed
FPGA Cyclic Redundancy
Check Failed
Unexpected Error
Device Built-In Self Test
Status All
Device Reset
Device Temperature
Selector
Device Temperature
Device ID
Calibration Date
Device Acquisition Type
Sensor
Device TL Type
GigE Vision
Device TL Version Major
Device TL Version Minor
Power-up Configuration
Selector
None
Factory Setting
UserSet1
UserSet2
DFNC Major Rev
DFNC Minor Rev
•
30 Operational Reference
UserSetLoad
UserSetSave
deviceBIST
deviceBISTStatus
Passed
FirmwareUpdateFailure
FPGA_CRC_Failure
Unexpected_Error
deviceBISTStatusAll
DeviceReset
DeviceTemperatureSelector
DeviceTemperature
DeviceID
deviceCalibrationDateRaw
deviceAcquisitionType
Sensor
DeviceTLType
GigEVision
DeviceTLVersionMajor
DeviceTLVersionMinor
UserSetDefaultSelector
None
Default
UserSet1
UserSet2
deviceDFNCVersionMajor
deviceDFNCVersionMinor
Loads the camera configuration set specified by the
User Set Selector feature to the camera and makes it
active. (W)
Saves the current camera configuration to the user
set specified by the User Set Selector feature. The
user sets are located on the camera in non-volatile
memory. (W)
Command to perform an internal test which will
determine the device status. (W)
Return the status of the device Built-In Self Test.
Possible return values are device-specific.
No failure detected.
Last firmware update operation failed.
FPGA cyclic redundancy check failed.
Switched to recovery mode due to unexpected
software error.
Return the status of the device Built-In Self Test as a
bitfield. The meaning for each bit is device-specific.
Resets the device to its power up state. (W)
Select the source where the temperature is read.
The temperature of the selected source in degrees
Celsius
Displays the device's factory set serial number.
Date when the camera was calibrated.
Displays the Device Acquisition Type of the product.
(RO)
The device gets its data directly from a sensor.
Transport Layer type of the device.
GigE Vision Transport Layer
Major version of the device's Transport Layer.
Minor version of the device's Transport Layer.
Selects the camera configuration set to load and
make active on camera power-up or reset. The
camera configuration sets are stored in camera
non-volatile memory. (RW)
Keep Internal configuration.
Select the Factory Setting values as the Power-up
Configuration.
Select UserSet1.
Select UserSet2.
Major revision of Dalsa Feature Naming Convention
which was used to create the device's XML. (RO)
Minor revision of Dalsa Feature Naming Convention
which was used to create the device's XML. (RO)
Linea SWIR GigE Series Camera
1.00
Beginner
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
Invisible
1.00
DFNC
Invisible
1.00
DFNC
Invisible
1.00
Invisible
1.00
Invisible
1.00
Invisible
1.00
Invisible
1.00
DFNC
Invisible
1.00
DFNC
Invisible