Cardinal 210 Installation And Technical Manual page 69

This addendum is to inform you of changes to the 200, 205, 210 and 215 Weight Indicators.
This addendum should be used in addition to the Installation and Technical Manual for your
indicator. Refer to the manual for information concerning the installation, setup, and operation
of your 200, 205, 210 or 215 Weight Indicator.
LINEARIZATION FOR GUARDIAN SCALE
Beginning with version 2.6.4 of the firmware, an additional prompt has been added after the
CAL? section of the setup.
If a GUARDIAN scale is connected to the indicator, at the SST? prompt press the
YES key.
The tLo= prompt will be displayed. This is the low end of the range of weight that
requires adjusting. For example, if after performing linearization testing, the
displayed weight is 5 lbs low between 10,000 lbs and 15,000 lbs, the value for the
tweak low weight is 10000.
Input the tweak low weight value and then press the ENTER key.
The tHi= prompt will be displayed. This is the high end of the range of weight that
requires adjusting. Using the example above, the value for the tweak high weight is
15000.
Input the tweak high weight value and then press the ENTER key.
The tUAL= prompt will be displayed. This is the amount of weight that needs to be
added (or subtracted) from the range of weight to bring the displayed weight into
tolerance. Again, using the example above, the Tweak Weight value would be 5.
Input the tweak weight value (pressing the NET key will change the sign) and then
press the ENTER key.
When the indicator is turned on, it will display SST for a couple of seconds if the SST? prompt
was answered YES in setup.
ADDENDUM FOR MANUALS:
8200-M035-O1 Rev B, 8200-M024-O1 Rev G and H, 8200-M411-O1 Rev C and D
02/11
Technical Support: Ph: 866-254-8261  techsupport@cardet.com
Addendum to the
200, 205, 210 and 215
Installation and Technical Manual