Cardinal 210 Installation And Technical Manual page 23

OVER/PWC3 (210 Only)
This annunciator is used to signal that the displayed weight is equal to or greater than the
minimum value of over weight used in the Checkweigher feature. Note that this annunciator
is active only when the Checkweigher feature has been enabled.
The PWC3 annunciator is turned on to indicate that the displayed weight is equal to or
greater than the weight value stored as preset number 3. Note that this annunciator is active
only when the Preset Weight Comparator feature has been enabled.
tn (210 Only)
This annunciator is located to the right of the weight display and is turned on to show that the
displayed weight unit is tons.
g
This annunciator is located to the right of the weight display and is used to indicate that the
displayed unit of weight measurement is grams.
lb
This annunciator is located to the left of the weight display and is turned on to show that the
displayed weight unit is pounds.
oz
This annunciator is located to the right of the weight display and is turned on to show that the
displayed weight unit is ounces.
kg
This annunciator is located to the left of the weight display and is used to indicate that the
displayed unit of weight measurement is kilograms.
t (210 Only)
This annunciator is located to the right of the weight display and is used to indicate that the
displayed unit of weight measurement is tonnes (metric tons).
PIECES (210)
COUNT (215)
This annunciator shows that the display is in the Count mode and the value displayed is the
count quantity and not weight.
TOTAL (215 Only)
This annunciator shows that the display is in the Count mode and that the value displayed is
the current contents (total) of the count accumulator.
8200-M411-O1 Rev D  210/215 Installation & Technical
ANNUNCIATORS
19