Cardinal 210 Installation And Technical Manual page 65

This addendum is to inform you of changes to the 200, 205, 210 and 215 Weight Indicators.
This addendum should be used in addition to the Installation and Technical Manual for your
indicator. Refer to the manual for information concerning the installation, setup, and operation
of your 200, 205, 210 or 215 Weight Indicator.
Beginning with version 2.6.1 of the firmware, an additional prompt has been added to the A-d
section of the setup.
If the indicator is to function as a remote indicator, press the YES key at the SErSCL
prompt. If not then press the NO key at the prompt.
If SErSCL was set to YES then, an additional prompt has also been added in the SIO
section for selecting the port for the LOCAL/REMOTE communications.
At the LrP prompt enter either 1 for port 1 or 3 if the optional 2xx-RS232 card is
being used.
IMPORTANT!
If a 200, 205, 210 or 215 indicator is to be used as the LOCAL and as the REMOTE, then both
indicators MUST have Rev 2.6.1 or greater software installed.
If a combination of 200, 205, 210 or 215 and a 225 indicator are to be used in a
LOCAL/REMOTE configuration, then the 200, 205, 210 or 215 indicator MUST have Rev 2.6.1
or greater software installed, and the 225 indicator MUST have Rev 1.0.K or greater software
installed.
 This operation is not support with a 220 indicator. 
ADDENDUM FOR MANUALS:
8200-M035-O1 Rev B, 8200-M024-O1 Rev G and H, 8200-M411-O1 Rev C and D
02/11
Technical Support: Ph: 866-254-8261  techsupport@cardet.com
REMOTE INDICATOR SETUP
200, 205, 210 and 215 Rev 2.6.1 Addendum
Addendum to the
200, 205, 210 and 215
Installation and Technical Manual
1