Cardinal 210 Installation And Technical Manual page 34

SETUP AND CALIBRATION, CONT.
Dual-Point without Zero (False Zero) Calibration
CAL1= – First Calibration Weight
The display will show CAL1=0. This is the first of two calibration steps. This weight is
the TEST WEIGHTS / TEST LOAD.
• Place the weights on the scale platform.
• Using the numeric keys, input the value of the calibrated test weights / test load, then
press the ENTER key. NOTE! When entering values for CAL1=, the digits start
displaying on the right side of the display and proceed to the left. When large values
are used (more than 3 digits), the CAL1= prompt will automatically scroll off the left
side of the display to show the additional digits on the right as they are entered.
• Starting at the left and proceeding right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the
display will show: CAL2=.
CAL2= - Second Calibration Weight
The display will show CAL2=0. This is the second of two calibration steps.
• Remove the weights on the scale platform, then press the NET/GROSS key.
• Starting at the left and proceeding right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the display
will show: Sio?.
Single-Point for Span Only (Last Zero) Calibration
CAL1= – First Calibration Weight
The display will show CAL1=0. This is the first of two calibration steps. This weight is
the TEST WEIGHTS / TEST LOAD.
• Zero the scale, then place the weights on the scale platform.
• Using the numeric keys, input the value of the calibrated test weights / test load, then
press the ENTER key. NOTE! When entering values for CAL1=, the digits start
displaying on the right side of the display and proceed to the left. When large values
are used (more than 3 digits), the CAL1= prompt will automatically scroll off the left
side of the display to show the additional digits on the right as they are entered.
• Starting at the left and proceeding right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the
display will show: CAL2=.
CAL2= - Second Calibration Weight
The display will show CAL2=0. This is the second of two calibration steps.
• Remove the weights on the scale platform, and then press the ZERO key.
• The display will advance to Sio?.
8200-M411-O1 Rev D  210/215 Installation & Technical
30