Cardinal 210 Installation And Technical Manual page 19

Consecutive Number
If the consecutive number displayed is correct, press the ENTER key to resume normal
operation. If the consecutive number displayed is incorrect, use the numeric keys to enter
the correct consecutive number (up to 6 digits) and press the ENTER key to resume normal
operation.
PRESET KEY
This key is used to enter the weight values for the three preset weight comparators or for the
checkweigher feature depending on which feature was selected (setup parameter d out)
during setup and calibration.
Preset Weight Comparator
If the Preset Weight Comparator feature was selected, the PWC1 annunciator will flash and
the display will show the currently stored value for the number 1 preset weight comparator.
If the value displayed is acceptable, press the ENTER key, otherwise, use the numeric keys
to enter the new preset value and press the ENTER key. The PWC2 annunciator will now
flash and the display will show the currently stored value for the number 2 preset weight
comparator. As before, if the value displayed is acceptable, press the ENTER key,
otherwise, use the numeric keys to enter the new value and press the ENTER key. The
PWC3 annunciator will now flash and the display will show the currently stored value for the
number 3 preset weight comparator. Again, if value displayed is acceptable, press the
ENTER key, otherwise, use numeric keys to enter a new value and press the ENTER key.
Checkweigher
If the Checkweigher feature was selected and the PRESET key pressed, the ACCEPT and
UNDER annunciators will flash and the preset value for the minimum acceptable weight will
be displayed. Press the ENTER key if the displayed value is correct or use the numeric
keys and enter the new value and press the ENTER key. The ACCEPT and OVER
annunciators will now flash and the display will show the minimum value of weight over the
accepted range. As before, if the value shown is correct, press the ENTER key. If the value
is incorrect, enter the new value and press the ENTER key to save it. Note that this value
must be greater than the accept value. Remember that both the preset weight comparators
and checkweigher functions operate on the absolute value of weight ignoring the polarity.
After the second preset value is entered, the indicator will return to normal operation.
PRINT KEY
Pressing this key will add the displayed gross or net weight or piece count to the associated
accumulator and initiate the transmission of weight and other data selected during setup of the
Print menu items via the selected printer output port (see Port= under Print menu) unless the
continuous data feature of this port was enabled during setup and calibration.
If the id= (ID Prompt) has been enabled during setup, when the PRINT key is pressed, the
indicator will prompt for an ID to be printed on the ticket.
If the A clr= is set to 1 (Yes), input up to 6 digits for the ID and then press the ENTER key
to complete the transaction. Upon pressing the ENTER key, the print function will occur.
If the A clr= is set to 0 (no), press the ENTER key to display the current ID. If ID
displayed is acceptable, press the ENTER key again to complete transaction. Otherwise,
input up to 6 digits for ID then press the ENTER key to complete the transaction. The print
function will occur after the ENTER key is pressed.
Note that the indicator will not respond to the Print command unless the weight display is
stable. If displaying gross weight, the only weight printed is gross weight. If displaying net
weight, the gross, tare, and net weights are printed.
8200-M411-O1 Rev D  210/215 Installation & Technical
KEYPAD FUNCTIONS, CONT.
15