Cardinal 210 Installation And Technical Manual page 25

SETUP AND CALIBRATION, CONT.
Pressing the calibration switch at any prompt will return you to the SEtUP menu. To exit
setup, press the ASTERISK key with any of the above menu selections displayed or cycle
power at any time (press the ON/OFF key twice).
NOTE! With the exception of the SEtUP prompt, the prompts displayed for each section
are different if you push the calibration switch instead of pressing the ENTER key to
proceed through the section. For example, if you press the calibration switch with the
SEtUP displayed, the next prompt displayed will be A-d. If you step through the setup
prompts by pressing the ENTER key, the next prompt displayed will be A-d?. In addition,
at a prompt with the ? displayed, you must press the ENTER key, the 1/YES key then the
ENTER key again to proceed with that section. To skip the section and advance to the next
menu selection, press the ENTER key twice.
S E t U P
USA= (Domestic or International)
With SEtUP displayed, press the ENTER key. The display will change to USA=. Press the
ENTER key to show the current value. If the setting displayed is acceptable, press the ENTER
key again to save it. Otherwise, using the numeric keys, 0/NO or 1/YES, enter the new setting,
then press the ENTER key to save it.
USA=1 (Domestic)
Date = mm/dd/yy
Trl = no
Cap + 4% to OC
If you selected USA = 0 (International), an additional prompt, "PASS=" will be displayed.
If you selected USA = 1 (Domestic) proceed to LFt= (Legal For Trade).
PASS (Password Y/N)
The PASS (Password Y/N) prompt determines whether a password is required to enter Setup
and Calibration on indicators programmed for international use. Note that this prompt is only
displayed when USA = 0 (International) is selected.
With the display showing PASS, press the ENTER key to show the current value. If the setting
displayed is acceptable, press the ENTER key again to save it. Otherwise, using the numeric
keys, 0/NO or 1/YES, enter the new setting, then press the ENTER key to save it.
PASS (No)
Password protection is not needed.
Setup advances to the LFt= prompt
Press the ENTER key to see the current password value. If the password displayed is
acceptable, press the ENTER key again to save it. Otherwise, using the numeric keys enter
the new password (up to 6 digits) and then press the ENTER key to save it.
Password Operation
With the PASS prompt enabled (set to YES), anytime the operator tries to enter Setup, the
display will show the PASS= prompt requiring the operator to enter the correct password. If
the wrong password is entered the indicator displays ERROR momentarily and returns to the
weight mode. Note that the password is not displayed when the operator is entering it.
It is recommended to write the password down and store it in a secure location. If the
password is forgotten or lost and a change to the indicator setup is required, the indicator
must be reprogrammed. WARNING! Reprogramming the indicator will erase all the
contents of the Nov-Ram and memory.
8200-M411-O1 Rev D  210/215 Installation & Technical
USA=0 (International)
Date = dd/mm/yy
Trl = yes
Cap + 9 grads to OC
PT printed with tare
Lamp test on power up
PASS (Yes)
Password protection is desired. The
next prompt will be PASS=
21