Download Print this page

Cardinal 2-OU Series Installation Manual

Checkweigher light bar

Advertisement

Quick Links

2XX-OU
CHECKWEIGHER LIGHT BAR
INSTALLATION MANUAL
8200-M119-O1 Rev-B
203 E. Daugherty, Webb City, MO 64870 USA
Printed in USA
Ph: 417-673-4631  Fax: 417-673-2153
09/12
www.cardinalscale.com
Technical Support: Ph: 866-254-8261 • tech@cardet.com
8200-M119-O1 Rev B  2XX-OU Installation
1

Advertisement

loading

Summary of Contents for Cardinal 2-OU Series

  • Page 1 2XX-OU CHECKWEIGHER LIGHT BAR INSTALLATION MANUAL 8200-M119-O1 Rev-B 203 E. Daugherty, Webb City, MO 64870 USA Printed in USA Ph: 417-673-4631  Fax: 417-673-2153 09/12 www.cardinalscale.com Technical Support: Ph: 866-254-8261 • tech@cardet.com 8200-M119-O1 Rev B  2XX-OU Installation...
  • Page 2: Fcc Compliance Statement

    STATIC ELECTRICITY PRECAUTION CAUTION! This device contains static sensitive circuit cards and components. Improper handling of these devices or printed circuit cards can result in damage to or destruction of the component or card. Such actual and/or consequential damage IS NOT covered under warranty and is the responsibility of the device owner.
  • Page 3: Installation

    INSTALLATION To Begin Installation 1. Unplug the indicator AC power cord from the AC socket-outlet. 2. Remove the three acorn nuts securing the Battery Access Cover to the bottom of the indicator and then remove the battery tray on the Model 215 or the battery (if equipped) on the Model 210.
  • Page 4 INSTALLATION, CONT. Cable Installation 1. Loosen an unused cable gland connector for the light bar cable. 2. Insert the cable end with the two, 2-pin, connectors through the gland connector and into the enclosure. 3. Plug the two connectors, side-by-side into the IIC P8 connector on the main pcb as shown in the figure below.
  • Page 5 INSTALLATION, CONT. Installing the Light Bar Referring to the figure below, place the Light Bar on the top 3 threaded studs then install and finger-tighten the acorn nuts to hold the Light Bar in place. Install and finger-tighten the remaining acorn nuts. Following a diagonal pattern, tighten the acorn nuts, securing the back panel and Light Bar to the enclosure.
  • Page 6: Part Identification

    PART IDENTIFICATION 8200-M119-O1 Rev B  2XX-OU Installation...
  • Page 7 PART IDENTIFICATION ITEM NO. PART NO. DESCRIPTION 593GR986 SERIAL TAG ASSEMBLY 6013-0039 NUT HEX #6-32 6013-0433 NUT HEX #10-32 ACORN SS 6610-2248 CONN GLAND .187-.312 GRIP .599 MTG BLK 6680-0004 WASHER LOCK INT. TOOTH #6 Z/P 6680-0027 SPACER (PCB) #6 X .312 8200-B108-08 REAR COVER, 2XX-OU 8200-B109-08...
  • Page 8 8200-M119-O1 Rev B  2XX-OU Installation...

This manual is also suitable for:

215210