Wake-Up; Check Engine Light Quick Clear - banks iDash 1.8 DataMonster Owner's Manual

SETTINGS,

12.10 Wake-up

Figure 12-8
12.10.1 Sensitivity Level
The iDash 1.8's automatic wake-
up uses battery voltage drop when
cranking the vehicle. The wake-up
sensitivity level allows you to adjust
the iDash 1.8's sensitivity to the
voltage drop. Some vehicles have
greater voltage drops than others and
would need to set the sensitivity to
the low setting.
If the gauge is interfering
with OnStar or other similar services,
decrease the sensitivity one level
lower.
To adjust the wake-up sensitivity
level:
1.
Select "Settings" from the main
"MENU."
2.
Select "Wake-up Sensitivity
Level."
3.
Select the desired sensitivity level
("Sensitivity Level: Low",
"...Medium", "...High").
See Figure 12-8.
If unsure, set to "Sensitivity Level:
Low" and then:
A. Turn off your vehicle and
wait for the iDash to go to
Sleep Mode.
62
97654 v.7
CONTINUED
B. Restart your vehicle and
the iDash should start within
10 seconds after startup.
C. If it does not automatically
wake-up, press any button
to wake. Increase sensitivity
level by one and repeat the
process.
12.10.2 Start/Stop
For vehicles with engine start/stop
functionality: When enabled, the
iDash 1.8 will not shut off when
RPM drops below 600 rpm. Instead,
the vehicle will check for vehicle
communication to the ECU to
determine if the vehicle is shut off.
It will also take longer for the
iDash 1.8 to go into sleep mode.
To enable or disable "Start-
Stop":
1.
Select "Settings" from the main
"MENU."
2.
Select "Wake-up Sensitivity
Level."
3.
Select "Start-Stop:" to "Enable"
or "Disable" this feature.
See Figure 12-8.
4.
Return to the Gauge Screen when
finished.
12.11 Check Engine Light
Quick Clear
The Quick Clear setting allows you
to clear diagnostic trouble codes
without having to access the vehicle's
diagnostic menu.
If enabled, a screen will appear once
the check engine light is detected to
ask if you would like to clear vehicle
codes.
Check engine light may recur