Data Play Back On Gauge(S) - banks iDash 1.8 DataMonster Owner's Manual

DATA LOGGING (IF EQUIPPED),
If the Micro SD card is plugged in after
the vehicle is started, the iDash 1.8 will
automatically start data logging once the
Micro SD card is recognized.
Parameters logged will be the
parameters set before the iDash 1.8
went into "Sleep Mode."
To end the log, hold the "DOWN" button
while on the Gauge Screen until the
iDash 1.8 states "Stop Data Logging:
Log###.csv".
To enable "Auto Log":
1.
Select "Data Logging" from the
main "MENU."
2.
Select "Auto Log:" to enable or
disable. See Figure 6-1.
6.4 Data Play Back on
Gauge(s)
The iDash 1.8 playback feature allows
you to view the recorded data on the
Gauge Screen of all connected iDash
1.8's.
When viewing the Gauge Screen
of the primary iDash 1.8, a blue box
at the top of the display will flash
indicating playback mode is on. When
playback is turned off, this indicator
will not appear.
To set up play back:
1.
Select "Data Logging" from the
main "MENU."
2.
Select "Start Play back" to
open the list of saved data logs
currently on the Micro SD card.
See Figure 6-1.
3.
Select the desired data log file for
play back.
4.
Configure the Gauge Screen
layout ("Section: 4, LAYOUT"
on page 28) and parameters
displayed ("5.1 Parameter
Selection" on page 30) to
show the parameters that were
recorded. See for instructions on
set up.
A useful parameter to display
on the Gauge Screen during playback
mode is "Time Data Log."
At any time, parameters
displayed on the Gauge Screen can be
changed during play back.
The data will begin playing on the
iDash Gauge Screen. The blinking
blue box at the top indicates that
playback is active.
Only parameters that were
recorded on the log will be able to be
shown. If a parameter shows "--" it
was most likely not configured as a
logged parameter at the time of the
data log recording.
Navigating playback options during
playback mode:
To pause data playback, press the
BACK button on the iDash 1.8.
To resume data playback, press the
BACK button a second time.
While data playback is paused,
pressing the UP or DOWN buttons
will move ahead or back one line of
data per press (0.1 seconds). Holding
the UP or DOWN buttons will skip 5
seconds at a time.
While data playback is running,
pressing the UP or DOWN buttons
will skip ahead or back by 5 seconds.
Holding the UP or DOWN buttons will
skip 30 seconds ahead or back
CONTINUED
33
97654 v.7