Banks Module Specific Layouts - banks iDash 1.8 DataMonster Owner's Manual

LAYOUT,
Density is calculated from
various vehicle sensors and will only
be available if your vehicle is equipped
with the proper sensors.
To select the Density layout follow
the instructions in "4.1 Layout
Selection" and select the "Density
Dark" or "Density Light" layout. You
will automatically be returned to the
"Gauge Screen."
4.2.1 Field 1 Parameter
Selection
In this layout, only "Field 2" through
"Field 4" can be changed with user
selectable parameters. "Field 1" of
this layout is configured to only display
"MAD" (Manifold Air Density) or
"BAD" (Boost Air Density).
To change, press the "Select" button
on "Field 1" to switch between these
options
4.2.2 Density Bar Graph
When displaying "MAD," the green
dashed line indicates your current
"AAD" (Ambient Air Density). The
red and blue section of the bar graph
represents "MAD" (considering 0 to
be the same baseline for "AAD" and
"MAD"). See Figure 4-2.
If the MAD bar graph is only blue, your
MAD is less than AAD. If the Bar graph
is blue and red, the red portion of the
bar graph represents your current
boost air density (BAD).
When displaying "BAD," only the blue
bar graph will be displayed.
To adjust the scaling on the bar graph
shown in "Field 1" of the Density layout:
1.
Select "Gauge Selection" from
the main menu.
2.
Press select on "Density Scale:"
to change the scaling of the bar graph.
Options are 125, 200, 300, 400 and 500.
CONTINUED
Figure 4-2 – Density Light Layout
4.3 Banks Module Specific
Layouts
For the Derringer B-Bus Tuner, Six-Gun
Tuner, EconoMind Tuner, and SpeedBrake
here are special layouts that appear in
the "Layouts" menu when a module is
connected.
4.4 Custom Pages
A page consists of a layout, and the
parameters within it. Once you've
changed the layout to your liking, it
will automatically be saved as Page 1.
1.
To create new page, go to "Menu"
and select "Gauge Selection."
2.
Select "Load Custom Page."
3.
Select "Page 2," and any change
to your configuration on that page
will be automatically saved.
The iDash can store up to 5
page configurations at once.
4.
To switch between pages, hold the
"LEFT" button for 2 seconds.
4.4.1 Custom Pages
1.
To disable a custom page, go to
"Menu" select "Settings."
2.
Select "Custom Page Enable" to
choose which pages to turn off, or
back on again once disabled.
29
97654 v.7