Simple B-Bus Network - Single Idash 1.8; Part Number List - banks iDash 1.8 DataMonster Owner's Manual

MOUNTING AND CONNECTING THE
IDASH,
CONTINUED

2.5 Part Number List

iDash and Data Input Cable
iDash 1.8 SuperGauge CAN bus ................................................................ 62882
iDash 1.8 Banks Bus 1 CAN Bus ............................................................... 62885
OBD-II Cable (Standard) CAN Bus ......................................................... 61300-35
OBD-II Cable (Banks Bus 1) CAN Bus ................................................. Various P/N
Aftermarket ECU Cable .....................................................................61301-36
Aftermarket ECU Termination Cable ...................................................61301-27
Banks Bus In Cab Cables
B-Bus Starter Cable ............................................................................61301-20
B-Bus In Cab Terminator Cable (HW Rev 1) ..........................................61301-23
B-Bus Termination Jumper (HW Rev 2) ................................................61300-30
B-Bus In Cab Y-Adapter ......................................................................61301-22
B-Bus Extension Cable (24") ...............................................................61301-24
B-Bus Extension Cable (48") ...............................................................61301-25
Banks Bus Under Hood Cables
B-Bus Under Hood Termination Cap .....................................................61300-22
B-Bus Under Hood Extension Cable (24") ............................................61300-23
B-Bus Under Hood Extension Cable (48") .............................................61300-24
B-Bus Under Hood Extension Cable (72") .............................................61300-25
2.6 Simple B-Bus Network
- Single iDash 1.8
The simple B-Bus network can
consist of one iDash 1.8 Gauge,
an In-Cab Terminator OR Jumper
Block Termination, a B-Bus Starter
Cable, a B-Bus Module, and a Black
Termination Cap. See Figure 2-10.
If using a single iDash Gauge:
1.
If you have a HW Rev 1 iDash
1.8:
A. Connect the Starter
Cable to the In-Cab
Terminator. See Figure
2-10, Step A.
B. Connect the In-Cab
Terminator to the iDash
6-Pin Port. See Figure 2-10,
Step B.
If you have a HW Rev 2
iDash 1.8:
A. Connect the Starter
16
97654 v.7
Cable to the iDash 6-Pin
Port (Without the In-Cab-
Terminator). See Figure
2-10.
B. Confirm that the Jumper
Block is connected to the
iDash 2-Pin termination.
See Figure 2-12.
Figure 2-9
Jumper Block
Terminator
(HW Rev 2)
6-Pin
4-Pin
Step Step
2B
A
In-Cab
In-Cab
Terminator
Terminator
(HW Rev 1)
(Rev 1 Only)
NOTICE
Only use one
In-Cab Term.
B-Bus
OR
Starter
one Jumper
Cable
Block
P/N
OBD-II Cable
(Standard)
OR
OBD-II Cable
(Banks Bus 1)
OR
Aftermarket
ECU Harness
Step Step
Step
2A
B
B
OBD-II Cable
Or
Aftermarket ECU
Harness