No Obd Or Aftermarket Ecu Connection; General Idash 1.8 Mounting - banks iDash 1.8 DataMonster Owner's Manual

2.3 No OBD or Aftermarket
ECU Connection
Refer to iDash 1.8 Aftermarket ECU
Setup Owner's Manual 97670 for
aftermarket ECU wiring instructions.
2.4 General iDash 1.8
Mounting
If you bought an iDash 1.8 Guage Pod or
A-Pillar mount, follow the instructions
provided in the kit.
All iDash 1.8 come with a Mounting
Sleeve to mount to any aftermarket
gauge mount.
To install the iDash 1.8 with the
provided hardware:
1.
Place the mounting sleeve behind the
mounting surface and route the cables
to the iDash 1.8 through.
See Figure 2-9.
2.
Connect cables (i.e. OBDII,
Aftermarket ECU Harness, Starter Cable)
to the iDash 1.8 4-Pin and 6-Pin Ports.
3.
Insert the iDash 1.8's studs through
the Mounting Sleeve's holes.
See Figure 2-14.
4.
Hand tighten the nylon Thumb Nuts.
See Figure 2-9.
Mount sleeve
much of a press fit, the iDash 1.8
buttons may become unresponsive.
Untighten or sand the aftermarket mount
hole (Not the Mounting Sleeve) until you
have a clearance fit for the iDash 1.8. If
you do not want to use the mounting
sleeve, ensure the mount hole has a
press fit minimally applied, so that the
buttons remain functional.
Thumb Nuts
FIGURE 2-9
If the mount applies too
97654 v.7
15