Table of Contents
Advertisement
Reference Material
This section describes:
•
•
Network Port Requirements and Licensed Third-Party Software Used
by the Touchpanels
For information about network port requirements and licensed third-party software for the
TLP Pro 1220, 1520, and 1720 series touchpanels, see the Pro Series Control Product Network
Ports and Licenses Guide, which is available at www.extron.com.
Reset Modes
The TLP Pro 1220, 1520, and 1720 Series touchpanels have three reset modes that are initiated
by pressing the
•
•
•
The
Use Factory Firmware
This mode is used to boot up the unit with factory-installed firmware for a single power cycle
in the event of a firmware update that failed or incompatibility issues arising with user-loaded
firmware.
Activation
1.
2.
Result
The unit reverts to factory-installed firmware. Event scripting does not start if the unit is powered
on in this mode. All user files and settings such as drivers, adjustments, and IP settings are
maintained.
NOTE:
Network Port Requirements and Licensed Third-Party Software Used by the
Touchpanels
Reset Modes
button:
Reset
Use Factory Firmware
Reset All IP Settings
Reset to Factory Defaults
button is found on the rear panel (see
Reset
On the touchpanel, hold down the recessed
unit. When power is restored, the Reset LED lights. Hold the
seconds before releasing it. The touchpanel enters factory firmware mode.
Upload new firmware to the unit as desired (see
NOTE:
Do not continue to operate the touchpanel using the factory firmware version. If
you want to use the factory default firmware, you must upload that version again (see
Updating the
Firmware).
To return the unit to the firmware version that was running prior to the reset, cycle
power to the unit.
TLP Pro 1220, TLP Pro 1520, and TLP Pro 1720 Series • Reference Material
figure 3
on page 8).
button while applying power to the
Reset
Reset
button for a further two
Updating the Firmware
on page 23).
30
Advertisement
Table of Contents
