Reference Material; Network Port Requirements And Licensed Third-Party Software; Reset Modes; Use Factory Firmware - Extron electronics TouchLink TLP Pro 525C Series User Manual

Reference Material

This section describes:
•
•
•
•

Network Port Requirements and Licensed Third-Party Software

For information about network port requirements and licensed third-party software for the
touchpanels described in this guide, please refer to the Pro Series Control Product Network
Ports and Licenses Guide, which is available at www.extron.com.

Reset Modes

The touchpanels described in this guide have three reset modes that are initiated by pressing the
Reset
•
•
•
•
The

Use Factory Firmware

This mode is used to boot up the unit with factory-installed firmware for a single power cycle
in the event of a firmware update that failed or incompatibility issues arising with user-loaded
firmware.
Activation
To start the
1.
2.
3.
Result
The unit reverts to factory-installed firmware. Event scripting does not start if the unit is powered
on in this mode. All user files and settings such as drivers, adjustments, and IP settings are
maintained.
NOTE: To return the unit to the firmware version that was running prior to the reset,
Network Port Requirements and Licensed Third-Party Software
Reset Modes
Secure Sockets Layer (SSL) Certificates
IEEE 802.1X Certificates
button:
Use Factory Firmware
(see below)
Reset All IP Settings
(see below)
Reset to Factory Defaults
Enable or Disable the DHCP Client
button is found on the base of the touchpanel (see
Reset
Use Factory Firmware
Remove power from the touchpanel.
On the touchpanel, hold down the recessed
the unit. When power is restored, the Reset LED (
further 2 seconds before releasing it. The touchpanel enters factory firmware mode.
Upload new firmware to the unit as desired (see
NOTE: Do not continue to operate the touchpanel using the factory firmware
version. If you want to use the factory default firmware, you must upload that
version again (see
Updating the
cycle power to the unit.
TLP Pro 525C and 725C Series Touchpanels • Reference Material
(see following page)
(see following page)
reset mode and replace firmware:
button (
Reset
C
) lights. Hold the
Updating the Firmware
.
Firmware)
B
figure 3, , on page 6).
B ) while re-applying power to
button for a
Reset
on page 36).
37