Connecting A Two-Wire Mxbus Cable - Mobotix D26 Dome Manual

Network and Power Connection
• Remove the camera dome: Take the delivered plastic foil or a
cotton cloth, insert the dome into its seat and turn it in clock-
wise direction.
• Attach the outer shell: Place the outer shell onto the camera and
tighten all four Allen screws using the supplied Allen wrench.
Make sure that the rubber seal is seated properly.

2.9.7 Connecting a Two-Wire MxBus Cable

You can use such a cable to connect additional MOBOTIX mod-
ules (e.g., the MX-GPS-Box or the MX-232-IO-Box) to the D25.
Note that you can attach one MxBus cable (with two wires)
to the MxBus connector (red arrow in figure). Take care not
to switch the polarity of the wires. It is recommended to
use the same wire color for +/– for the entire MxBus system
(e.g., red = +, blue = –).
Procedure
• Uninstall camera: Remove the camera so you can access the
connectors on the back.
• Remove the outer shell: Remove all four Allen screws using
the supplied Allen wrench. Take off the outer shell.
• Remove the camera dome. Take the delivered plastic foil or
a cotton cloth and remove the dome by turning it in count-
er-clockwise direction.
In order to attach MxBus
modules, you need to
use the supplied MxBus
connector with two-wire
connection line and two
single-wire connectors:
The length of the entire
MxBus wiring must not
exceed 50 m/55 yd!
69