Mobotix D26 Dome Manual page 32

D26 Camera Manual: Installation
Stand/Wall Mount for Camera Tests (MX-OPT-TW-Demo-1)
The Stand/Wall Mount is a useful accessory for testing and for finding the optimum mounting
position of the camera. The set also includes an Allen wrench as well as a Torx screw with
dowel and the corresponding Torx wrench for installing as alternative wall mount for testing.
Using as a Stand (with/without tripod)
Using this stand, you can now place the camera upright on a flat surface or mount the whole
assembly on a tripod (1/4" tripod thread at the bottom of the stand).
Converting to a wall mount (simulation of On-Wall set with 10 deg. tilt)
1. If required, release the two stainless steel Allen screws
2. Place the camera with the two upper body
32
and remove the camera from the stand/wall mount.
screws exactly into the two receptacles
of the Stand/Wall Mount.