Mobotix D26 Dome Manual page 50

D26 Camera Manual: Installation
The blue winged cams
(see left) automatically
secure the In-Ceiling
Set in the ceiling when
tightening the screws
Installing the decorative
ring:
turn clockwise
Removing the decorative
ring:
turn counter-clockwise –
only relevant when com-
pletely removing the camera
50
7. Insert the camera and the In-Ceiling Set into the hole: Make sure that all winged
cams are retracted before placing the In-Ceiling Set with the camera into the hole.
Tightening the screws of the In-Ceiling Set extends the winged cams, thus firmly
holding the set in place.
8. Install the decorative ring: Use the two wrenches from
the In-Ceiling Set to place the ring on the set as shown in
the figure and turn the ring clockwise until it stops.
The two wrenches from the In-Ceiling Set are also used
for dismounting. Insert them as shown and turn the ring
counter-clockwise. Loosen the screws of the In-Ceiling
Set; this will automatically retract the winged cams. You
can now remove the In-Ceiling Set, with the camera still
attached, from the ceiling.
9. Proceed to Section 3.3.1, «Aiming and Adjusting the Lens».