Mobotix D26 Dome Manual page 57

Installing the Wall Mount
3. Pass the camera cable up through the bottom of the
bottom plate: Ensure the orientation is correct. The spring
clips should be on the underside of the bottom plate.
4. Snap the camera into place on the bottom plate: Firmly
push the camera into the Wall Mount. The plastic spring
clips will snap into place when the trapezoidal elements
on the rear of the camera housing exactly match up with
the corresponding openings on the Wall Mount.
5. Mount the Wall Mount (without camera): Stick the black wall sealing to the back of
the Wall Mount (remove the adhesive foil first, the surface must be clean and free of
grease). Pass the network cable through the large square opening and into the Wall
Mount. Use the included screws to install the Wall Mount (without the camera) at
the intended position. Pass the network cable through the large square opening on
back side of the Wall Mount.
6. Connect the cable: Prepare the on-site network cable for
connection with the camera patch cable using a standard
connector. Excess cable can be stored easily within the
Wall Mount.
7. Install the bottom plate with the camera in the Wall
Mount: Connect the camera patch cable to the network
cable. Then mount the bottom plate with the camera in
the slots from below and fix it in place on the Wall Mount
using the 4 Allen screws (Allen wrench included).
8. Proceed to Section 3.3.1, «Aiming and Adjusting the Lens».
57