Procedure - Mobotix D26 Dome Manual

Mounting the Camera with the In-Ceiling Set

2.4.2 Procedure

1. Prepare the network connection: Run the network cable above the suspended ceiling
and ensure that enough cable slack is available.
2. Cut a hole for installation: Cut a round hole for camera
installation (e.g. with a 150 mm hole saw). Use the cutting
template of the In-Ceiling Set.
3. Remove the camera outer shell: Remove all four Allen
screws using the supplied Allen wrench and lift off the
outer shell (not mounted upon delivery).
4. Remove the mounting ring: Separate the mounting ring from the camera housing.
This ring is not required to mount the camera in the In-Ceiling Set.
5. Place the camera in the In-Ceiling Set: The dovetail guides
at the back of the camera housing fit exactly into the
openings of the In-Ceiling mounting ring. To make the
camera even more secure (e.g. for mobile use), push the
four clamps (item 3.4) into the square notches above the
dovetail guides until you hear them click into place.
6. Connect the cable: Connect the on-site network cable to
the camera network cable using a standard connector.
49