Mobotix D26 Dome Manual page 45

Mounting the Camera with the On-Wall Set
6. Remove the mounting ring: Separate the black mount-
ing ring from the camera housing (lift the spring clip).
This ring is not required when mounting the camera to
the On-Wall Set.
7. Connect the cable: Connect the on-site network cable
to the network cable passing through the On-Wall Set
using a standard connector. Make sure to leave enough
unused cable inside the housing. This will ensure that you
can turn and tilt the lens mount freely later on. Excess
cable can be easily stored within the On-Wall Mount.
8. Attach the camera to the mount: Press the D26 so that
it is seated firmly within the On-Wall Mount. The tapered
guides at the back of the D26 housing fit exactly into the
openings of the On-Wall Mount. Attach the white outer
shell with the supplied Allen screws (without rubber seal)
once the lens has been adjusted.
9. Proceed to Section 3.3.1, «Aiming and Adjusting the Lens».
45