Connecting Mxbus Modules - Mobotix D14D Manual

First Installation Steps
10. Secure the cable: Properly lead the cable through
the cable guides at the outer rim of the housing and
make sure that the outer shell can be properly
mounted later on.
11. Attach the outer shell: Hold the outer shell so that
the round hole of the shell is positioned over the PIR
sensor of the camera. Gently press the shell into the
shell's seats in the camera housing. Old outer shells
(D10D, D12D) may no longer be used!

2.3.5 Connecting MxBus Modules

The MxBus connection of the camera is located under the
cable cover and enables additional modules to be operated
to extend the functions of the camera. MxBus was optimized
specifically for the use of existing two-wire cables.
The white (detachable) MxBus connector has four connections
(each of which is blue/red or +/–):
• 2x MxBus inputs to connect the D14D to the MxBus cable
• 2x MxBus outputs to connect an MxBus module to the D14D
The MxBus wires that are to be stripped at the end should always be inserted into
the camera before installation. In doing so, every individual
wire (coming from the housing floor) should be pushed
through the elastic sealing membrane.
Do not mix up the polarity of the cables during installation.
Select a consistent cable color for +/– in the entire MxBus
system.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Note
61
/132
You are free to choose
the position of the
cable for the MxBus
connector's inputs and
outputs (left or right)