Table of Contents
Advertisement
Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
1.4 ISPnano Programmer Module - Main Features
The main features of the 'ISPnano Programming Module' are detailed in this section. This module is
found in the ISPnano Programmer, ISPnano-ATE programmer and also the ISPnano-MUX2 / MUX4 /
MUX programming Systems.
Wide ranging Device Support capability
Supports In-System Programming (ISP) of many popular FLASH Microcontrollers, Serial
•
EEPROM and serial FLASH Memories
High-speed Programming
Optimised algorithms, on-board project data storage and high-speed line-driver circuitry delivers
•
the fastest possible programming times
Supports most ISP Protocols
SPI, JTAG, I2C (2-wire), SCI, BDM,
•
Series 3 programmers only – Atmel XMEGA 2-wire PDI, ATtiny TPI(LV), ATtiny TPI(HV)
•
High-speed JTAG port
Supports high-speed JTAG programming of Atmel AVR and AT91SAM7 microcontrollers
•
High-speed SPI port
Supports full range of SPI speeds from 10 Hz up to 4 MHz
•
Dedicated 2-wire I2C serial port with independent drive circuitry
Supports high-speed I2C programming of Serial EEPROM and F-RAM memories.
•
Fully ESD and Over-voltage protected I/O
All Target I/O pins feature both ESD and over-voltage protection
•
Supports programming at Target Voltages down to 1.8V
An optimised driver circuit delivers fast clean programming waveforms from 1.8 to 5.0V.
•
Excellent Host Control connectivity
ISPnano Series 1
2 x RS232 Serial Ports
•
1 x RS485 In/OUT port – supports up to 32 programmers on an RS485 network
•
4-wire TTL Remote Control Port
•
Remote Keypad / Display (ideal for standalone control in a Test Fixture)
•
ISPnano Series 2
1 x USB Port
•
1 x RS232 Serial Port
•
1 x RS485 In/OUT port – supports up to 32 programmers on an RS485 network
•
4-wire TTL Remote Control Port
•
Advertisement
Table of Contents
