Equinox Systems ISPnano I Series User Manual page 37

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
11 EQTools / ISP-PRO
PC requirements
12 Power Supply
Options
13 Voltage range
14 Vpp Voltage
Generator
15 DC Power Connector
(2-pin JST
connector)
16 External DC Power
Connector
(2-pin JST
connector)
18 Target SPI
Frequency
20
ASCII Text Communications Mode (as standard)
•
ConsoleEDS (chargeable upgrade)
•
ISP-PRO (chargeable upgrade)
•
PC running Windows 95 / 98 / 2000 / ME / NT4 / XP /
Windows 7
There are 2 possible modes for powering the Programmer /
Target System:
Programmer controls power to the Target System
•
Programmer and Target System are independently
•
powered
Device Programming voltage range: 1.8 – 5.0V
•
Programmer Controlled Power Supply range: 1.8 – 5.0V
•
Possible Target System voltage range: 1.8 – 5.0V
•
User-programmable 6.5V – 13.5V Vpp Voltage
•
Generator
DC Power Connector for powering the programmer
2-pin JST connector
•
9.0V – 24.0V DC regulated @ 500mA (worst case)
•
Mates with Power Supply Adaptor supplied with
•
programmer
DC Power Lead fitted with 2-pin JST connector is also
•
supplied with programmer if a custom power supply is
to be used.
External DC Power Connector for externally powering the
Target System
2-pin JST connector
•
3.0V – 24.0V DC regulated @ 500mA (worst case)
•
This supply can be used to switch an external power
•
supply to the Target System under programmer control.
Software SPI algorithm:
SLOW SPI: 0 – 490.2 kHz (user selectable)
•
MEDIUM SPI: 0 – 490.2 kHz (user selectable)
•
( SPI speeds are estimations only due to uneven mark/space
ratio and non-continuous waveforms)
Hardware SPI algorithm
SLOW SPI: 115.2 kHz to 3.6864 MHz (user selectable)
FAST SPI: 115.2 kHz to 3.6864 MHz (user selectable)
•
ISPnano Series Programmer - User Manual – V1.11 – 12
th
May 2011