Ispnano Series Ii / Iii - Rear Panel Connections - Equinox Systems ISPnano I Series User Manual

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
1.9 ISPnano Series II / III – Rear panel connections
The illustration below details the function of each of the connectors on the rear panel of the
programmer.
1
# Connector Name
1 DC Power Input
2 EXTERNAL TARGET VCC
INPUT
3 Programmer STATUS LEDs Programmer 'Status' LEDs
4 RS485 Ports
5 USB Port
6 RS232 Port (2)
or Remote Display Keypad
16
2
3
Description / comment
DC Power Input to power the programmer
Voltage range: 9.0 – 24.0 V DC (right-hand pin positive)
•
EXTERNAL TARGET VCC INPUT
DC Power Input to power the programmer
•
Voltage range: 3.0 – 24.0 V DC (right-hand pin positive)
•
From Left to right:
•
PASS (GREEN)
•
BUSY (YELLOW)
•
FAIL (RED)
•
RS485 Ports (1) + (2) - Serial Communications Ports
These port can be used to control the programmer via an
•
RS485 link from a PC. They are connected in parallel internally
so it does not matter which is used as the RS485 INPUT or
OUTPUT.
The connector is a 5-pin 2.54mm Molex.
•
USB Port
This port can be used to control the programmer via a USB link
•
from a PC or other Test Equipment.
RS232 Port (2) - Serial Communications Port
This port can be used to control the programmer via an RS232
•
link from a PC or other Test Equipment.
ISPnano Series Programmer - User Manual – V1.11 – 12
4
5
6
th
May 2011