Table of Contents
Advertisement
Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of EQ-IOCON-3 - MOD PPM3 CONN-3 I/O ATMEGA JTAG
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
6.0 IO-CON-1 Module
6.1 Overview
This IO-CON module is designed for use with any Atmel microcontroller which can be programmed
via the 3-wire SPI port + RESET. Supported devices include the Atmel 89S, AT90S, ATmega and
ATtiny devices families. The module features the Equinox and Atmel 10-way ISP headers plus two
'Fast connect connectors' which allow wires to be manually clipped in. Please refer to Section 3 for a
detailed description and pin-out of the 6-way and 10-way ISP headers.
6.2 Features
•
Plugs into suitable Equinox programmer eg. PPM3 Module
•
Atmel 10-way IDC ISP Header
•
Atmel 6-way IDC ISP Header
•
Equinox 10-way IDC ISP header
•
'Fast Connect' clip-in connectors for direct wiring to Test Fixture i.e wires from bed-of-nails
probe wires
•
Screw terminals for power connections
•
Target Vcc Status LED
•
Link to connect / isolate the programmer Vcc from the Target Vcc
6.3 Support Device Families
This I/O Connection Module supports ISP programming of the following device families:
Low / High Voltage SPI programming algorithm:
•
Atmel AT89S (LV SPI)
•
Atmel AT90S (LV SPI)
•
Atmel ATtiny (LV SPI)
•
Atmel ATtiny (High Voltage)
•
Atmel ATmega (LV SPI)
•
Atmel 90CAN (LV SPI)
•
Atmel 90USB (LV SPI)
•
Atmel 90PWM (LV SPI)
•
Atmel ATmega PICO (LV SPI)
•
Zensys ZW (LV SPI)
I2C Serial EEPROM programming algorithm:
•
Atmel AT24C
•
Atmel AT24HC
•
Atmel AT34C
UART – Boot Loader' algorithm:
•
Atmel T89C51Rx2 (UART – Boot Loader)
•
Philips P89C51Rx2 (UART – Boot Loader)
•
Philips P89C66x (UART – Boot Loader)
Advertisement
Table of Contents
