Table of Contents
Advertisement
Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
3.4 USB Port
3.4.1 Overview of USB connection
It is possible to connect a single 'ISPnano Series III' programmer to a controlling PC using the high-
speed USB interface. The USB interface provides a high-speed method of uploading programming
projects to the programmer. It works by installing a 'Virtual COM Port (VCP)' on the host PC which
our EQTools / ISP-PRO / ConsoleEDS utilities then communicate through.
Please note:
The USB connector on the programmer is a 'mini-USB' connector.
•
It is NOT possible to power the programmer via the USB port.
•
3.4.2 USB Driver - Installation Instructions
1. Make sure the USB cable is NOT connected between the PC and programmer
2. Install the 'USB Driver' – see Application Note AN126 for further instructions.
The 'USB Driver' can be found as follows....
i. On the CD-ROM which came with the programmer
The driver should be in the following sub-folder on the CD:
\USBDrivers\PPM4-MK1_ISPnano_SeriesII
ii. On the Equinox website
The latest USB Driver can always be found on the Equinox Website. This version may be more up-to-
date than the one on the CD-ROM so it is usually a good idea to check the website version first.
To download the USB Driver, please browse to the following web page:
http://www.equinox-tech.com/products/downloads.asp?details=286
*** Make sure the USB Driver is installed before going to step (3) ***
46
ISPnano Series Programmer - User Manual – V1.11 – 12
USB Port
th
May 2011
Advertisement
Table of Contents
