Hardware Installation Procedure; Esd Precautions; Unpacking The Programmer And Accessories; Selecting The Communications Mode - Equinox Systems ISPnano I Series User Manual

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com

2.2 Hardware Installation Procedure

Please follow the instructions below to set up the programmer hardware:

2.2.1 ESD Precautions

2.2.2 Unpacking the programmer and accessories

The ISPnano 'programmer kit' comes complete with the IPSnano programmer, CONMOD Module,
RS232 serial cable, USB cable and various ISP cables. Please see the 'System Contents' section.

2.2.3 Selecting the Communications Mode

The ISPnano programmer range can be controlled via RS232, RS485 or USB.
Please see section 3 for a full explanation of each communications mode.

2.2.4 Powering the ISPnano programmer

The ISPnano programmer requires a power supply of 9.0 – 24.0V to be connected to the 'DC IN' 2-
pin JST connector on the rear panel of the programmer – see illustration below.
24
Ensure you are wearing an ESD strap and/or you are working in an ESD
•
protected environment.
The programmer I/O lines are ESD protected, but it always good practice
•
to take proper ESD precautions. This can help to avoid ESD damage to
either the programmer or Target System.
ISPnano Series Programmer - User Manual – V1.11 – 12
th
May 2011