Programmer Target I/O Capability; Supported Programming Interfaces - Equinox Systems ISPnano I Series User Manual

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com

1.5.4 Programmer Target I/O Capability

Target I/O Capability
Programmable Target
I/O
I/O Voltage Range
I/O Isolation
ESD protection on
Target I/O lines
Over-voltage
protection on Target
I/O lines

1.5.5 Supported programming interfaces

Programming
Interface
SPI Port
JTAG Port
I2C Port
UART Port
XMEGA PDI Port
ATtiny TPI Port (LV)
ATtiny TPI Port (HV)
Programmable clock
output
Please note:
The 'SPI Port', 'JTAG Port' and 'UART' port signals all share the same physical programmer
•
I/O lines.
This means that the programmer can only be connected via one of these programming
•
interfaces at any one time.
Series I Series II
5 x I/O 5 x I/O
1 x O
1.8 – 5.0V 1.8 – 5.0V
-
IEC61000-4-2, air IEC61000-4-2, air
discharge: 15 kV discharge: 15 kV
IEC61000-4-2, IEC61000-4-2,
contact discharge: contact discharge:
8kV
YES
Voltages over 9V are Voltages over 9V
clamped. are clamped.
Series I Series II
Yes - multiplexed Yes - multiplexed
Yes - multiplexed Yes - multiplexed
Yes - Dedicated Yes - Dedicated
Yes - multiplexed Yes - multiplexed
-
-
-
Yes
32 kHz 32 kHz
Series III
5 x I/O
1 x O 1 x O
1.8 – 5.0V
-
-
IEC61000-4-2, air
discharge: 15 kV
IEC61000-4-2,
contact discharge:
8kV 8kV
YES YES
Voltages over 9V
are clamped.
Series III
Yes - multiplexed
Yes - multiplexed
Yes – multiplexed
with PDI port
Yes - multiplexed
Yes – multiplexed
-
with I2C port
Yes – multiplexed
-
with I2C port
Yes – multiplexed
-
with I2C port.
+12V VPP on
RESET pin
Yes Yes
32 kHz
Series III
ATE
5 x I/O
1 x O
1.8 – 5.0V
Galvanic Relay
isolation per I/O
signal, power & 0V
IEC61000-4-2, air
discharge: 15 kV
IEC61000-4-2,
contact discharge:
8kV
YES
Voltages over 9V
are clamped.
Series III
ATE
Yes - multiplexed
Yes - multiplexed
Yes – multiplexed
with PDI port
Yes - multiplexed
Yes – multiplexed
with I2C port
Yes – multiplexed
with I2C port
Yes – multiplexed
with I2C port.
+12V VPP on
RESET pin
Yes
32 kHz