Equinox Systems ISPnano I Series User Manual page 70

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
Change the 'New Address' field to be the address you want to give the attached programmer
•
e.g. address 5
Click <OK>
•
The programmer should now confirm that the correct address has been stored.
Click <OK>
•
The 'Address' in EQTools is now also updated to your new address e.g. address 5 – see
•
screenshot below.
Click <Close>
•
The attached programmer will now only respond to EQTools if the 'Communications
•
Address' in EQTools matches the 'Node address' you stored in the programmer.
Please note:
The 'Communications Node Address' can only be set by connecting to the programmer
•
using either of the RS232 ports. It cannot be set when connected to the programmer via the
RS485 port.