Programmer Status Leds - Equinox Systems ISPnano I Series User Manual

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com

2.5 Programmer Status LEDs

The current status of the programmer is displayed on the programmer Status LED's as detailed in the
table below.
Fig. 2.6.5 Programmer Status LED's – state descriptions
Status LED State
Display
WAITING
BUSY
FAIL
PASS
Status LED key:
Please note:
There are also two special modes called 'Waiting Target Connection' or 'Waiting Target
•
Disconnection' where the yellow BUSY LED will FLASH.
These modes are enabled when 'Target Connection Sense' is enabled in the Programming
•
Project.
State Description
Programmer is now waiting to start an
•
'Autoprogram' operation.
Programmer is 'BUSY' performing a
•
programming operation.
If the programmer is controlled from
•
EDS, the BUSY LED will remain on
after a programming operation until a
'RESET programmer' command is
executed.
Programming operation has FAILED.
•
See programmer LCD for diagnostics
•
Programmer will automatically switch off
•
target power if it is controlling power.
Programming operation was successful.
•