Equinox Systems ISPnano I Series User Manual page 23

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
Remote Keypad / Display (ideal for standalone control in a Test Fixture)
•
Gang Programming support
Up to 32 programmers can be controlled from a single PC using the RS485 Bus
•
Standalone Operation
Programmer can operate in 'Standalone Mode' i.e. without PC Control.
•
Programmer can be controlled via [START] button, 4-wire TTL Remote control Port, Target
•
Detection or Lid switch detection control methods or Remote Keypad / Display.
Supports up to 64 Independent 'Programming Projects'
Each project supports programming of a complete device inc.
•
FLASH, EEPROM, Fuses etc.
High accuracy Programmer Controlled Target Vcc Power Supply
The programmer can switch 1.8 to 5.0V @ 300mA to the Target System.
•
Accuracy +/- 20 mV
•
Programmer controlled Target Discharge Circuit
The programmer can automatically discharge any residual charge on the Target System to
•
guarantee that the Target Vcc reaches 0V.
High accuracy Programmer Controlled Target Vpp Power Supply
The programmer can switch 6.5V to 13.5V @ 100mA to the Vpp pin of a Target IC.
•
User-swappable I/O Connector Modules (optional)
Many different I/O Connector Modules are available to suit any required connection system.
•
Firmware upgradeable
New algorithms and features can be added via a simple firmware upgrade
•
Compact physical size ideal for integration into Test Fixtures
Programmer measures only 9cm x 6cm x 6cm and has ergonomic design to supports the
•
maximum packing density.
Special ATE programmer version with RELAY isolation available (option)
All programmer ISP and power signals are galvanically isolated via relays.
•
Special multiplexed programmer version available
A single ISPnano programmer is multiplexed sequentially to either 2, 4 or 8 Target Boards
•
(UUTs) in turn.
6 ISPnano Series Programmer - User Manual – V1.11 – 12
th
May 2011