Front Panel Layout - Equinox Systems ISPnano I Series User Manual

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com

1.1 Front panel layout

The layout of the front panel of the programmer is shown below.
# Connector Name
1 DC Power Input
2 EXTERNAL TARGET VCC
INPUT
3 Programmer STATUS LEDs Programmer 'Status' LEDs
4 RS485 Ports
5 USB Port
6 RS232 Port
or
98
7
1 2 3
Description / comment
DC Power Input to power the programmer
Voltage range: 9.0 – 24.0 V DC (right-hand pin positive)
•
EXTERNAL TARGET VCC INPUT
DC Power Input to power relay coils
•
PASS (GREEN), BUSY (YELLOW), FAIL (RED)
•
RS485 Ports (1) + (2) - Serial Communications Ports
These ports can be used to control the programmer via an
•
RS485 link from a PC.
Up to 32 x ISPnano programmers can be connected on the
•
RS485 bus.
The connectors are connected in parallel internally so it does
•
not matter which is used as the RS485 INPUT or OUTPUT.
The connector is a 5-pin 2.54mm Molex.
•
High-speed USB Port
This port can be used to control the programmer via a USB link
•
from a PC.
RS232 Port - Serial Communications Port
This port can be used to control the programmer via an RS232
•
ISPnano Series Programmer - User Manual – V1.11 – 12
4 5 6
th
May 2011