Table of Contents
Advertisement
Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
4.4 Powering the programmer
4.4.1 Overview
The ISPnano programmer can be powered by any of the following methods:
#
Function
1
Using AC – DC power
supply adaptor
2
Using an external power
supply
4.4.2 Powering the programmer using the AC Wall Adaptor
The ISPnano programmer kit comes with an 'AC Mains Adaptor' which converts 110 – 240V AC
mains to a 9V DC regulated supply suitable for use with the programmer. This can be used to power
the programmer – see connection diagram below.
Instructions:
Plug the 2-pin JST connector on the end of the power supply cable into the 2-pin socket on the
•
ISPnano programmer labelled "DC IN"
Select the correct mains connector for your country and fit this to the Mains Adaptor.
•
Plug the Mains Adaptor into a power socket and switch on the power.
•
The ISPnano programmer should power up and the 'STATUS LED' should illuminate.
•
68
Voltage range
Further description
9.0V
9.0 – 24.0V DC
ISPnano Series Programmer - User Manual – V1.11 – 12
This is the 9V DC power supply which
•
comes with the ISPnano kit.
This is an external power supply.
•
A 'DC Power Cable' is required to
•
connect to the 'DC IN' connector.
th
May 2011
Advertisement
Table of Contents
