Appendix 2 - Ispnano Series Iii (Ate) - Target Isp Connector Port; Programmer I/O Signals - Equinox Systems ISPnano I Series User Manual

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
Appendix 2 – ISPnano Series III (ATE) -
Target ISP Connector Port

1.1 Programmer I/O Signals

The ISPnano Series III / Series III ATE programmers feature the following programmable signal lines
which interface the programmer and the Target IC(s) to be programmed on the Target System:
5 x Programmable Input / Output lines
•
1 x Programmable Output only line
•
1 x 2-wire multi-function port supporting the following interfaces:
•
o I2C (Two Wire Interface)
o Atmel XMEGA 2-wire PDI port
o Atmel ATtiny 2-wire TPI port
1 x Dedicated RESET pin
•
The diagram below shows the available programmer I/O lines:
Please note:
These I/O signals are available on the 16-way IDC Connector labelled "ISP PORT" on the ISPnano
Series 1 and 2 programmers and labelled "Target ISP PORT" on the 'Series 3 ATE' programmer.