Table of Contents
Advertisement
Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
1.11 Programmer Specifications
The table below details the hardware specifications for the programmer. Please refer to the stated
section for further information about any specific parameter.
#
Parameter
1
Target Device
Support
2
Target Device
Programming
Interfaces
3
Operating modes
4
On-board FLASH
Memory Store
5
Project storage in
Memory Store
6
Keypad entry
7
Status LED's
10 PC Control Software The programmer can be controlled using:
Description / comment
See Device Support List (separate document)
The ISPnano Series I and II programmers supports the
following programming interfaces:
Atmel Low Voltage SPI
•
Atmel High Voltage SPI (+12V Vpp)
•
Atmel AVR JTAG (chargeable update)
•
Atmel (formerly Temic) 8051 Boot loader ISP
•
NXP (Philips) 8051 - Boot Loader ISP
•
Generic I2C (SDA + SCL)
•
ARM7 JTAG Debug Interface
•
The ISPnano Series III programmer supports all of the above
programming interfaces plus the following additional interfaces:
Atmel XMEGA 2-wire PDI interface
•
Atmel ATtiny 2-wire TPI interface
•
The programmer supports the following operating modes:
Development Mode (PC controlled)
•
Project Upload Mode (PC controlled)
•
Standalone Mode – Single Start button mode
•
Standalone Mode – Automatic Target Connect / Disconnect
•
Sensing
Standalone Mode - Remote Controlled via 'ASCII Text
•
Communications' RS-232 Serial Protocol
Standalone Mode - Remote Controlled via 4-wire TTL
•
Remote Control Port
PC controlled via ISP-PRO software (chargeable upgrade)
•
PC controlled via ConsoleEDS utility (chargeable upgrade)
•
128 Mbits (16 MBytes) FLASH Memory for Project
•
Storage
64 x Programming Projects
1 x <START> button
i.
3 x Status LED's located on the programmer:
<PASS>, <BUSY>, <FAIL>
ii.
3 x remote Status LED's can also be connected off-
board on a Test Fixture via the 'Remote System
Status' port.
iii.
1 x Bi-coloured status LED
EQTools (as standard)
•
Refer
to
section
Advertisement
Table of Contents
