Appendix 3 - Remote Control Port; Overview; Remote Control Port - Connector Pin-Out - Equinox Systems ISPnano I Series User Manual

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com

Appendix 3 - Remote Control Port

1.1 Overview

The 'Remote Control Port' features all the connections required to control the programmer via a
'4-wire TTL control' protocol or via a single 'Start Switch'. It also features connections for 'Remote
Status LEDs' which allows the Status LEDs to be mounted remotely on a Test Fixture.
The functions of the 'Remote Control Port' are as follows:
3 x Remote Status LEDs
•
1 x Remote 4-wire TTL Control Port (START, BUSY, PASS, FAIL)
•
1 x Remote START signal (for Test Fixture Lid Switch)
•
1.2 Remote Control Port – connector pin-out
The pin-out for the 'Remote Control Port' is detailed in the table below.
Pin Programmer
No Pin name
1 + 2 REMOTE PASS LED
3 + 4 REMOTE BUSY LED
5 + 6 REMOTE FAIL LED
7 REMOTE START
SIGNAL
8 REMOTE JIG SWITCH
Remote Control Port
The connector is a 14-pin bump-polarised IDC
connector with 0.1" pin spacing.
Pin 1 is the top right pin as shown in the diagram
opposite.
Input / Notes
Output
P Connect to Remote 'PASS' LED:
pin 1 - LED anode (+ve)
•
pin 2 - LED cathode (-ve)
•
P Connect to Remote 'BUSY' LED:
pin 3 – LED anode (+ve)
•
pin 4 – LED cathode (-ve)
•
P Connect to Remote 'FAIL' LED:
pin 5 - LED anode (+ve)
•
pin 6 – LED cathode (-ve)
•
I This is the TTL-4-wire Remote Control Port
•
'START' signal.
Connect to 'START' output of the Remote
•
System
I Connect to switch (normally open) on Test
•
Fixture lid.
When the lid is closed this signal can be used to
•
automatically start a programming operation.