Introduction; Ispnano Series Iii Programmer - Equinox Systems ISPnano I Series User Manual

Programmer

Table of Contents

Distributor of Equinox Technologies: Excellent Integrated System Limited

Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER

1.0 Introduction

The ISPnano series of ISP programmers are designed for high-speed In-System Programming (ISP)

of FLASH Microcontrollers and Serial Memory devices. Their compact size and abundance of

programming ports makes them ideal for integration into any Test Fixture or ATE System. They

supports programming of devices by most interfaces including SPI, JTAG, JTAG chain, SCI, I2C (2-

wire), XMEGA PDI, ATtiny TPI and UART Boot Loader. The fastest possible programming times are

guaranteed due to a combination of highly optimised algorithms, local storage of Project Data and

high slew rate Line Driver Circuitry.

The ISPnano series of programmers represents a scaleable ISP programming solution capable of

programming multiple PCBs on a 'PCB Panel'. This is made possible by networking up to 32 x

ISPnano programmers to a single PC. All programmers can then be configured to start

simultaneously under PC control.

The 'ISPnano Series III' is a state-of-the-art Production ISP Programmer designed for high-speed In-

System Programming (ISP) of FLASH Microcontrollers and Serial Memory devices. Its compact size

and abundance of programming ports makes it ideal for integration into any Test Fixture or ATE

System. It supports programming of devices by most interfaces including SPI, JTAG, JTAG chain,

SCI, I2C (2-wire) and UART Boot Loader. The fastest possible programming times are guaranteed

due to a combination of highly optimised algorithms, local storage of Project Data and high slew rate

Line Driver Circuitry.

The 'ISPnano Series III' is capable of operating in 'Standalone Mode' where any one of 64

independent 'Programming Projects' can be executed via a remote command. The programmer

also features a '4-wire TTL Remote Control interface' making it ideal for interfacing to any ATE or

In-Circuit Tester (ICT). A special 'Start Signal' can be used to detect when a Test Fixture lid has

been closed and thereby automatically start a programming operation.

The 'ISPnano Series III' is a scaleable ISP programming solution capable of programming multiple

PCBs on a 'PCB Panel'. This is made possible by networking up to 32 x ISPnano programmers to a

single PC. All programmers can then be configured to start simultaneously under PC control.

Table of Contents