Table of Contents
Advertisement
Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
2.8 Target System Connect / Disconnect detection
The ISPnano programmer has a special mode where it can automatically detect when a Target
System (UUT) is connected to or disconnected from the programmer. A load sensing technique is
used to detect the presence of the UUT. This method of UUT detection can be used to trigger a
'Standalone Programming Project' or even a sequence of chained projects to start.
The typical sequence of events is as follows:
Programmer waits for UUT to be connected (flashing BUSY LED)
•
Operator connects UUT to programmer
•
Programmer detects connection of UUT
•
Programmer automatically executes a sequence of Standalone Programming Projects
•
At the end of the programming sequence, the programmer will FLASH either the PASS or
•
FAIL LED
Programmer then goes into 'Target Disconnection Sensing' mode (flashing BUSY LED)
•
Operator removes the UUT
•
Programmer resets itself ready for the next UUT
•
Please see Application Note – AN113 for further instructions on how to set up your programmer to
operate in this mode.
2.9 Script Mode (ISP-PRO)
'Script Mode' is designed for production users who require logging of all programmer operations to a
database. This mode utilises the Equinox ISP-PRO software which allows execution of Programming
Scripts. It is possible to write scripts to program unique data such as serial numbers, calibration data
etc. It is also possible to control the programmer from a Remote Application written in eg. Labview,
Visual Basic, C++ etc.
In order to use 'Script Mode' with your programmer, it is necessary to purchase the relevant license
upgrade for ISP-PRO.Please see the Equinox Website for further details.
36
ISPnano Series Programmer - User Manual – V1.11 – 12
th
May 2011
Advertisement
Table of Contents
