Using The Conmod Module - Equinox Systems ISPnano I Series User Manual

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
O - Output from programmer to Target Device
I - Input to programmer from Target Device
P - Passive e.g. GROUND and power rails
N/C - Not connected
It is possible to connect the Zensys Target Board directly to the programmer 'Target ISP Connector'
or you can use the 'CONMOD – ISPnano Connector Module'.

1.7.2 Using the CONMOD module

It is possible to use the 'CONMOD – ISPnano Connector Module' to connect to a Zensys Target
Board. The 'CONMOD' board features the standard 'Equinox 10-way IDC' header which Zensys
have adopted for use on many of their evaluation boards. It can therefore be used to connect directly
to any suitable Zensys evaluation board.
The relevant connectors for Zensys Z-WAVE device programming are shown in the illustrated picture
of the 'CONMOD – ISPnano Connector Module' below...
Instructions
Referring to the annotated picture above
•
Plug the 16-way IDC cable supplied with the programmer between the programmer 'Target
•
ISP Port' (16-way IDC connector) and the CONMOD Module 16-way header (J7) – see arrow
(3).
92
1
ISPnano Series Programmer - User Manual – V1.11 – 12
2
4
3
th
May 2011