Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
3. Connect the supplied USB cable between the USB Port on the rear of the programmer and a spare
USB port either on the PC or a USB Powered Hub.
The PC should display a message "Found new hardware....."
Follow the on-screen instructions to install the USB Driver.
•
Please refer to Application Note AN126 for further instructions.
•
3.4.3 Selecting the USB – Virtual COM Port (VCP) in EQTools
Make sure the USB cable is connected between the programmer and PC
•
Power up the programmer
•
In EQTools, select <Programmer> <Communications and scripting settings>
•
Select the COM port which corresponds to the VCP which the programmer is connected to.
•
Click <Test> to test if the PC can communicate to the programmer via USB
•
Please refer to Application Note AN126 for further instructions on setting up and testing the USB
'Virtual COM Port'.