Wheel Angle Sensor Installation; Assemble The Wheel Angle Sensor (Was) - Raven SmarTrax Installation Manual
For mccormick mfwd mtx120-155, xtx 145-215, and ttx 190-230
Hide thumbs
Also See for SmarTrax:
- Calibration and operation manual (156 pages) ,
- Operation manual (73 pages) ,
- Installation manual (59 pages)
Table of Contents
Advertisement
CHAPTER
4
Assemble the Wheel Angle Sensor (WAS)
WAS Assembly
FIGURE 1.
Install one M10 stud linear sensor mount (P/N 103-0001-030) and one M10 jam nut (P/N 312-1001-035) on
1.
the base-end (where the cable connects) of the 250 mm non-contact linear wheel angle sensor (WAS) (P/N
063-0181-017).
Install the other M10 stud linear sensor mount and M10 jam nut on the rod-end of the WAS.
2.
Manual No. 016-5030-017 Rev. A
W heel Angle Sensor
C h a p t e r 4
Installation
25
Advertisement
Table of Contents
