CHAPTER
4
INSTALL WHEEL ANGLE SENSOR
WHEEL ANGLE SENSOR BRACKETS
1. Remove the existing hydraulic cylinder shields on the front of the tractor.
FIGURE 1. Remove Cylinder Shields on Front Axle
2. Using bracket (P/N 107-0172-666), U-Bolt (P/N 435-3003-059), and two 5/16" nuts, install the cylinder bracket
assembly on the cylinder rod end so the clamp sits in the groove on the gray rod end piece and face the
bracket toward the front of the machine.
016-5035-038 Rev. A
C AB COMPONENT AND
C H A P T E R 4
SENSOR INSTALLATION
27