Wheel Angle Sensor; Mounting Spy-Cable - Raven CRX ROS+RS1 Installation Manual

CRX/VIPER4+ ROS INSTALLATION | CRX/VIPER 4+ ROS - RS1 | RAVEN EUROPE GENERIC
1.2.8

WHEEL ANGLE SENSOR

For a correct operation of the Raven system a wheel
angle sensor is necessary. In various tractor types a
factory fitted wheel angle sensor is already mounted
on the front axle. For these tractor types a 'spy cable' is
available at Raven to use the factory fitted wheel angle
sensor for the Raven system. In this case it is not
necessary to install a Raven wheel angle sensor. Ask
Raven for more information about the availability for a
specific tractor brand or type.
1.2.9

MOUNTING SPY-CABLE

Take the following steps to mount a wheel angle
sensor spy-cable:
1. Follow the cable from the wheel angle sensor
on the front axle of the tractor to the first
connection in this cable.
2. Disconnect the connectors.
3. Connect the spy-cable in between the
connectors.
4. Connect the wheel angle sensor 5M cable to
the M12 connector of the spy-cable.
5. Mount the spy-cable in a clean and dry
position (Figure 14).
PAGE 19/36 | Installation manual | 016-8000-028EN | Rev. B
FIGURE 14 SPY CABLE MOUNTED ON A CNH
TRACTOR