Wheel Angle Sensor Installation - Raven SC1 Installation Manual

CHAPTER
3
1. Park the machine on a level surface, with the wheels pointing straight ahead.
FIGURE 1. Rotary Sensor Assembly Alignment
2. Align the flat side of the shaft on the rotary sensor assembly (P/N 063-0181-024) so that it is parallel with the
cable exit point as shown in the figure above.
FIGURE 2. WAS Installation Location
3. Remove the top bolt in the machine's kingpin on the right side of the axle as shown in Figure 2.

Wheel Angle Sensor Installation:

W HEEL ANGLE SENSOR
C H A P T E R 3
INSTALLATION
Flat Side
of Shaft
Cable
Exit Point
Existing Bolt
to be
Removed
9