Brake And Accelerator Unit - Sega Daytona Championship USA Owner's Manual

11-2 BRAKE AND ACCELERATOR UNIT

When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit. However, the unit must be
switched on when using test mode. Do not touch any part of the unit except the
11
areas indicated.
Be careful not to damage wires. Damaged wires may cause an electric shock,
short circuit or present a risk of fire.
This work should be performed by site maintenance personnel or other skilled
professionals. Work performed by non-technical personnel can cause a severe
accident such as an electric shock.
To prevent accidents while working or while operating the product after it has
been installed, be sure not to conduct any procedures other than those given
in this manual. There are cases in which procedures not covered in this manual
require special tools and skills.
If a procedure not given in this manual is required, request service from the office
given in this manual or from the point of purchase.
Be sure to perform volume's move value setting in the Input Test in the Game
Test Mode after replacing or adjusting the Volume.
If the accelerator or brake pedals are not functioning correctly, you may need to adjust the positioning of the volume
or replace it with a new one. In addition, you should apply grease to the gear contacts and spring parts once every
three months.
78