Greasing - Sega Daytona Championship USA Owner's Manual

7
Use a soldering iron to melt the solder and seperated the wires from the old volume pot. Be very careful
when using a soldering iron.
8
If the exposed conductive wire at the end is less than 5mm, use a tool such as a wire stripper or cutter to cut
the wire insulation back to a workable length. Place new sleeving over the wire before resoldering them to
the pot.
9
Once soldered, cover the bare contacts with the sleeving. If heatshrink is used, apply heat from an
appropriate hot air blower to shrink the sleeving tightly over the contacts.
10
Reassemble the pot to the pot bracket by working in reverse order of these instructions.
Refer to the POT VOLUME ADJUSTMENT section of this manual.

11-4 GREASING

Use only the specified grease. Using any other kind of grease can result in
damage to parts.
Once every three months, you should apply grease to the gear contacts and spring parts.
Use Grease Mate-brand spray grease (Part No.: 090-0066).
11-4 fig. 01
11-3 fig. 02
POTENTIOBASE
11
81