Sega Daytona Championship USA Owner's Manual page 84

• After the unit has been disassembled and reassembled again, check carefully
that the unit has been reassembled correctly.
• Be sure to inspect the outer covers on both gear and brake units.
• Assemble so that there is no gap between the L and R covers. If there is a gap
or rattling, the players could get fingers or hands caught, resulting in injury.
11
• Once the product has been disassembled, use slack preventive agent. Coat
screws with suitable amounts of this agent and then tighten them. If this agent is
not used, the product might start rattling or come apart.
• Use the slack preventive agent prescribed in these instructions. If any other
agent is used, there could be chemical changes that inhibit the use of screws
and part surfaces could be damaged.
• Be careful not to damage or lose small parts or screws.
• When a part has been replaced, be sure to always make adjustments and
check conditions in Test Mode.
76