Sega Daytona Championship USA Owner's Manual page 114

Linked cabinets will not sync to-
gether in the attract mode.
15
Cabinets are unable to start a Multi-
player session together.
The Steering Wheel does not work
correctly in the game.
The Pedals do not work correctly in
the game. Vehicles move forward
or backwards with no player input.
No audio can be heard in either
the attract mode, or throughout the
game.
High Score Tables have not been
cleared after attempting to clear
them in the Bookkeeping menu.
106
Network cables are not connected.
The cabinets are using security keys
from different regions
Network cables are faulty.
. Network cables are not connected.
Cabinet ID's are not set up cor-
rectly.
The Steering Wheel has not been
calibrated correctly.
The Pedals have not been calibrated
correctly.
The audio level has not been
correctly set with the Hardware
Volume Control.
The volume levels within the Sound
Settings in the Test Menu have not
been set correctly.
The high scores have only been
cleared on one cabinet when multi-
ple cabinets are linked together.
Reconnect the network cables to
each cabinet.
Ensure each cabinet has the same
region (viewable on the System
Information page of Test Mode).
Cabinets will only link together
from the same region.
Replace the faulty network cables.
Contact the company from whom
the unit was purchased.
Ensure network cables are properly
connected to the cabinets.
Go into the Network Settings and
ensure each cabinet has a different
Cabinet ID. Confirm the settings
and then the cabinets will reset
with the new changes saved.
Go into the Calibration Settings in
the Test Menu and select Calibrate
Steering.
Go into the Calibration Settings in
the Test Menu and select Calibrate
Brake and follow the on screen in-
structions. Once this has been done,
select Calibrate Accelerator and
follow the on screen instructions.
Adjust the Hardware Volume
Control until audio in the game can
be heard.
Enter the Sound Settings menu
from the Test Menu and check
that all volume levels are set to
the appropriate levels. Options are
available within this menu to test
the volume levels of each setting to
make sure each are correct.
When multiple cabinets are linked
together, the high score tables will
only be cleared if the process is
done on all connected machines at
the same time. Each cabinet must
be in the Bookkeeping menu, and
then Clear High Scores should
be selected on each one and then
confirmed. If any cabinets are left
in the attract mode during this,
the high score tables will not be
cleared.